Panasonic KX-TA624 Installation Manual page 77

3 Features
*9: The DISA Ring Timer Before Intercept starts. The destination telephone(s) will ring for the time
programmed in [508].
*10: In this case, the system does not accept a line access code. If nothing is recorded in OGM2 or
OGM2 is used for another caller, the caller will hear a busy tone and the call is disconnected.
*11: The OGM is sent to the caller according to programs [414]–[416] and [502] when the assigned
time in program [519] expires. If an OGM is not recorded, the DISA Wait Timer After OGM
programmed in [505] starts immediately.
When the system detects a FAX (CNG) tone while the OGM is being sent, the call is sent to the
FAX extension assigned in program [503]. When the system detects a cyclic tone or CPC signal
while the OGM is being sent, the call is disconnected.
*12: The DISA Wait Timer After OGM starts. The system waits for a number from the caller during
the time assigned in program [505]. When the system detects a FAX (CNG) tone during the
programmed time, the call is sent to the FAX extension. When the system detects a cyclic tone
or CPC signal during the programmed time, the call is disconnected.
*13: After the DISA Wait Timer After OGM or the Intercept Timer for Internal DISA expires, the
system regards that nothing was dialled.
*14: The system treats the call according to program [510] as follows.
• Disconnect – the call is disconnected.
• Intercept – the call is sent to the extensions programmed in [408]-[410]. If all extensions are
*15: The DISA Ring Timer After Intercept starts. The destination telephone(s) will ring for the time
programmed in [509]. If the call is not answered during the programmed time, the call will be
disconnected.
*16: The FAX extension assigned in program [503] receives the call. When the extension is busy, the
system sends a busy tone to the sending FAX. If the call is not answered after 40 seconds, the
call will be disconnected.
Program [514] sets how many times the FAX (CNG) tone must be detected before the system
recognises the incoming signal as facsimile data.
assigned to "Disable", the call will be disconnected.
D
3-27
Features