Panasonic KX-TA624 Installation Manual page 349

1.5 During a Conversation
Call Transfer using a DSS button
Allows you to perform a Screened or Unscreened Call Transfer by using a DSS button.
There are 2 operations, depending on whether or not One-Touch Transfer* is set.
* One-Touch Transfer allows you to hold an outside call and transfer it to an extension by pressing one key. This
feature provides automatic hold and transfer, without pressing the TRANSFER button. System Programming is
required to use this function.
"With Transfer" mode
PT
During a conversation
Press the flexible button
assigned as the DSS button.
• The other party is placed on hold and the destination extension
is called immediately.
"Without Transfer" mode
PT
During a conversation
Press TRANSFER.
!
• If the destination extension does not answer the call within a pre-determined time (default:
!
30 seconds), the call will return to you (Transfer Recall).
• If there is no answer within 30 minutes after "Transfer Recall" starts, the call will be
disconnected.
• When the dialled extension is busy, you may access the extension by dialling "2" (Busy
Extension Signalling) or "3" (Executive Busy Override) and going on-hook.
PT • If you want to return to the held call, press the TRANSFER button or corresponding line
key or INTERCOM button before the destination extension answers.
• A flexible line key can be assigned as a DSS button.
PT
PT • To use "One-Touch Transfer", System Programming is required.
PT • During a 5-party conference, you cannot transfer a call.
• If you want to return to the held call, press the Recall button before the destination extension
SLT
answers.
SLT • If "Hold-3" is assigned in System Programming, you must dial "50" after pressing the
Recall button.
• 1.2 Proprietary Telephone Settings, "Customising the Buttons on Your Telephone",
DSS (Direct Station Selection) Button
• See the Installation Manual, Section 3, "Call Transfer – to Extension".
TRANSFER
Press the flexible button
assigned as the DSS button.
1-43
Operations