Table of Contents
Advertisement
1.
Press the
2.
Press the
3.
Using either the
4.
Press either the
5.
Press the
6.
At this point Use the
•
TOL TIME = XXXXHR
•
TOL CAL = XXXX
•
TOL DIS = XXX.XMI
7.
When the message
your totals and reset the console to Idle mode.
D.
Clear Totals
To clear your user totals, follow the procedure below:
1.
Press the
2.
Press the
3.
Using either the
4.
Press either the
5.
The message
•
Press the
•
Use the
blinking will not reset your totals.
6.
After pressing the
E.
Measuring Units Setting
The measuring unit can be changed between English and Metric.
1.
Press the
2.
When the
DOWN key until the message "UNIT SETUP" comes up.
3.
Press the
"METRIC" depending on the settings of the console.
4.
Press either
5.
Press the
Mode.
F.
Sound Setting
The beeper on this units can be turned off and back on.
1.
Press the
2.
When the
DOWN key until the message "SOUND SETUP" comes up.
3.
Press the
"SOUND OFF" depending on the settings of the console.
4.
Press either
5.
Press the
1000Sr OM.indd 19
1000Sr OM.indd 19
Console Layout (Continued)
USER ZONE key.
ENTER key when the "USER SETUP" message comes on, in the message display.
UP or DOWN keys fi nd your profi le and press the ENTER key.
UP or DOWN keys until the message "REVIEW TOTALS" comes up.
ENTER key.
UP and DOWN keys to review your workout data.
– this is the total time you have worked out in hours.
– this is the total calories burned since the user data was last cleared.
– this is the total distance traveled since the user data was last cleared.
"EXIT" comes up in the display press the ENTER key to exit from reviewing
USER ZONE key.
ENTER key when the "USER SETUP" message comes on, in the message display.
UP or DOWN keys fi nd your profi le and press the ENTER key.
UP or DOWN keys until the message "CLEAR TOTALS" comes up.
"CLEAR TOTALS = YES" will come on with Yes blinking.
ENTER key when the Yes is blinking and the totals will reset to 0.
UP or DOWN keys to change the Yes to No. Pressing the Enter key when No is
ENTER key the Console will also reset to Idle mode.
USER ZONE key.
"USER SETUP" message comes on in the message display; press either the UP or
ENTER Key. At this time the message display will display either "ENGLISH" or
UP or DOWN key to select the preferred measuring units.
ENTER key. The measuring units will be changed and the console will reset to Idle
USER ZONE key.
"USER SETUP" message comes on in the message display; press either UP or
ENTER Key. At this time the message display will display either "SOUND ON" or
UP or DOWN key to select the preference.
ENTER key. The console will stop or start beeping and reset to Idle mode.
19
7/7/2008 2:28:08 PM
7/7/2008 2:28:08 PM
Advertisement
Table of Contents
