Table of Contents
Advertisement
Heart Rate Monitoring & Console
Heart Rate Monitoring Device
Pulse Hand Grips (Standard)
The 1000Sr unit is heart rate controlled and comes standard with stainless steel pulse handgrips. To acti-
vate, gently grasp both handgrips to obtain a heart rate reading.
(Note: It is recommended to wear a chest strap for Heart Rate control program, as it is more accurate.
If you wear a chest strap and use hand grips at the same time for heart rate monitoring purpose, please
note the console will take the measurement of the chest strap.)
Operating Tips:
If you are not getting a consistent reading while using the hand pulse option, we recommend the follow-
ing suggestions:
•
Make sure that the palms of the hands are touching the contact area of each hand pulse grip.
•
Maintain an even pressure on the grips.
•
Do not hold the hand pulse grips too tightly.
Chest Strap (Standard)
The 1000Sr is equipped a built-in receiver and a chest strap for your heart rate monitoring. To get an ac-
curate reading using these devices, you will need to be within three feet of the console, and a minimum
of four feet from others using a heart rate monitoring device.
(Note: The transmitter may fl uctuate erratically if you are too close to other heart rate monitoring equip-
ment or there is other electronics nearby, such as TV, Radio...)
The receiver of the wireless ECG system is built into the console unit of the Diamondback 1000Sr equip-
ments. While using heart rate control modes, the computer monitors the exact measurement of and
control over the activity if the heart. Heart rate frequency is displayed while the computer continually
compares heart rate to the preprogrammed personal data. The computer adjusts the wattage to main-
tain heart rate at the preprogrammed level.
How to Wear Your Sensor/ Transmitter
1.
Buckle one end of the chest strap onto the transmitter.
2.
Adjust the band length so that the fi t is snug, but not too tight.
3.
Buckle the other end of the chest strap onto the transmitter.
4.
Center the transmitter on your chest below the pectoral muscle (breasts).
5.
Stretch the transmitter away from your chest and moisten the conductive electrode strips located
next to the buckles with water.
(Note: The transmitter is on automatically when being worn. It is off when it is not connected to your
body. However, as moisture may activate the transmitter, thoroughly dry the transmitter to prolong bat-
tery life.)
Console
Glossary of Terms
•
Idle mode = Console is reset and waiting for an entry. The message display window will fl ash
a message of "Select a program".
•
LED = the lights on the face of the console.
1000Sr OM.indd 12
1000Sr OM.indd 12
12
7/7/2008 2:27:59 PM
7/7/2008 2:27:59 PM
Advertisement
Table of Contents
