Maintenance - Diamondback 1000Sr Step-Thru Reference Information

CAUTION – FOR SAFE OPERATION
Always inspect hardware prior to any exercise session. Look for loose hardware, loose pedals, loose
cranks and frayed wires. Repair or replace any damaged or worn parts,tighten all loose hardware.
As part of Diamondback's normal installation and set-up process, all pedal cranks must be tightened af-
ter 8 to 10 hours of initial riding to ensure parts are properly seated to axle. This is standard initial "break-
in" service, which must be performed after the fi rst 8 to 10 hours of use. Un-tightened pedal cranks may
become loose, causing damage, which may void the warranty.
After exercising, always wipe down your unit. Perspiration that continuously settles on frame, pads or
casing may eventually cause rust or damage to the unit. Damage resulting from lack of proper mainte-
nance will not be covered under warranty. To clean pads, use a mild soap and warm water. Dry with a
clean towel.
If noises develop or malfunctions occur, contact your authorized Diamondback Fitness
dealer.
1000Sr OM.indd 40 1000Sr OM.indd 40

Maintenance

40
7/7/2008 2:28:11 PM 7/7/2008 2:28:11 PM