Download  Print this page

Mitsubishi Electric FR-A520-0.4K -55K Instruction Manual Page 28

Transistorized inverter, high function & low acoustic noise.
Hide thumbs

Advertisement

( 5 ) Connecting the control circuit to a power supply separately from the main circuit
If the magnetic contactor (MC) in the inverter power supply is opened when the protective circuit is operated,
the inverter control circuit power is lost and the alarm output signal cannot be kept on. To keep the alarm
signal on terminals R1 and S1 are available. In this case, connect the power supply terminals R1 and S1 〈L
〉 of the control circuit to the primary side of the MC.
and L
21
• Model FR-A520-0.4K to 3.7K, FR-A540-0.4K to 3.7K
<Connection procedure>
R1 〈L
11
S1 〈L
21
• Model FR-A520-5.5K to 55K, FR-A540-5.5K to 55K
<Connection procedure>
R1
S1
〈L
〈L
11
21
Power supply terminal
block for control circuit
R
S
T
〈L
〈L
〈L
1
2
3
MC
Main power supply
Note: 1. When the main circuit power (R, S, T) 〈L
(terminals R1, S1 〈L
2. When using a separate power supply, the jumpers across R-R1 and S-S1 〈L
must be removed. Otherwise the inverter may be damaged.
3. For a different power supply system which takes the power of the control circuit from other than
the primary side of the MC, the voltage should be equal to the main circuit voltage.
4. For the FR-A520-5.5K to 55K, FR-A540-5.5K to 55K, the power supply cables must not be
connected to the lower terminals. If connected, the inverter may be damaged.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
R
〈L
〉 S
1
〈L
〉 T
2
〈L
3
Terminal block for main circuit
1) Loosen the upper screws
2) Remove the lower screws.
3) Remove the jumpers.
4) Connect the separate power supply cables for control circuit to the
lower terminals (R1, S1 〈L
L
, L
1
2
3
〉). Otherwise the inverter may be damaged.
, L
11
21
17
INSTALLATION AND WIRING
〉). (Note 4)
, L
11
21
Power supply terminal
block for control circuit
1) Loosen the upper screws.
2) Remove the lower screws.
3) Pull out and remove the jumper.
4) Connect the separate power supply
cables for control circuit to the
upper terminals (R1, S1 〈L
〉). (Note 4)
, L
11
21
〉 is on, do not switch off the control power
-
L
1
11
-
and L
L
11
2
21

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: