PG follower (Note 4)
Master controller (Note 4)
Soft starter (Note 4)
Deviation detector (Note 4)
Preamplifier (Note 4)
Pilot generator (Note 4)
Deviation sensor (Note 4)
potentiometer (Note 4)
Frequency meter (Note 4)
Calibration resistor (Note 4)
Inverter setup software
Note: 1. "H" in the type code indicates 400V class.Power supply specifications of FR series controllers
and setters: 200VAC 50Hz, 200V/220VAC 60Hz, 115VAC 60Hz.
2. Rated power consumption
3. The intercompatibility attachment (FR-A5AT
exception of some models.
4. Options available in Japan only.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Application, Specifications, etc.
For follow-up operation using the signal of a pilot
generator (PG). (2VA)
For parallel operation of several (up to 35) inverters.
For soft start and stop. Allows parallel operation and
For synchronous operation. Used with a deviation sensor
and synchro. (5VA)
Can be used as A/V conversion or operational amplifier.
For follow-up operation. 70/35VAC 500Hz (at 2500rpm)
For synchronous operation (mechanical deviation
detection). Output 90VAC/90°
For frequency setting. Wire-wound type. 2W1KΩ B
Dedicated frequency meter (up to 120Hz scale). Moving-
coil DC ammeter.
For calibration of the frequency meter. Carbon-film type.
Supports steps from inverter start-up to maintenance.
(FR-SW0-SETUP-WJ is Japanese version.)
) is required to mount the inverter, with the