Sp Mode Table; Sp1-Xxx: (Feed) - Ricoh B156 Service Manual

5.1.2 SP MODE TABLE

In the "Function/[Setting]" column:
• The related pop-up screen name and function name (if any) appear in
parenthesis following the function description.
• Comments are in italics.
• The setting range is enclosed in brackets, with the default setting written in
bold.
• An asterisk (*) after the mode number means that this mode's value is
stored in the NVRAM. If you do a RAM reset, all these SP modes will be
returned to their factory settings.
• DFU stands for Design/Factory Use only. Values marked DFU should not be
changed.
• An SP number set in bold-italic (e.g. x-001-1) denotes a "Special Service
Program" mode setting.
NOTE: The Service Program Mode is for use by service representatives only, so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.

SP1-XXX: (Feed)

Mode No.
1
(Class 1, 2, and 3)
001* Lead Edge
1 Tray 1: Plain
2 Tray 1: Thick
3 Tray 1: OHP
4 Tray 2: Plain
5 Tray 2: Thick
6 Tray 2: OHP
7 Tray 3
8 Tray 4
9 By-pass: Plain
10 By-pass: Thick
11 By-pass: OHP
12 Duplex
002* Side-to-Side
1 By-pass
2 Tray 1
3 Tray 2
4 Tray 3
5 Tray 4
6 Duplex
SM
CÓPIA NÃO CONTROLADA
Adjusts the leading edge registration by changing the
registration clutch operation timing for each mode.
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step]
The user mode cannot adjust the settings for thick paper
or OHP sheets.
NOTE: When adjusting SP1-001-2 or 3, check SP1-001-
1 first. SP1-001-2 and 3 adjust the differences
between the leading edge registration positions
for the following paper types:
1: Plain paper and thick paper
2: Plain paper and OHP
In the same manner, when adjusting SP1-001-5
or 6, check SP1-001-4 first; and when adjusting
SP1-001-10 or 11, check SP1-001-9 first.
Adjusts the side-to-side registration by changing the
laser main scan start position for each mode.
[–4.0 ~ 4.0 / 0.0 / 0.1 mm/step]
NOTE: When adjusting SP1-002-1, 3, 4, 5, or 6, check
SP1-002-2 first. SP1-002-1, 3, 4, 5, and 6 adjust
the differences in the side-to-side registrations
between each paper tray and tray 1.
5-5
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function / [ Setting ]
B156/B220