Ricoh B156 Service Manual page 672

BIT SWITCHES
I-fax Switch 04
No FUNCTION
0 Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI
of the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI
or CSI is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the
Subject line that indicates where the transmission originated can be used to determine
automatically the destination folder for each e-mail.
1-7 Not Used
I-fax Switch 05
No FUNCTION
0 Mail Addresses of SMTP Broadcast Recipients
Determines whether the e-mail addresses of the destinations that receive
transmissions broadcasted using SMTP protocol are recorded in the Journal.
For example:
"1st destination + Total number of destinations: 9" in the Journal indicates a broadcast
to 9 destinations.
0: Not recorded
1: Recorded
1-7 Not Used
I-fax Switch 06 - Not used (do not change the settings)
I-fax Switch 07 - Not used (do not change the settings)
I-fax Switch 08
No FUNCTION
0-7 Memory Threshold for POP Mail Reception
This setting determines the amount of SAF (Store and Forward) memory. (SAF stores
fax messages to send later for transmission to more than one location, and also holds
incoming messages if they cannot be printed.) When the amount of SAF memory
available falls below this setting, mail can no longer be received; received mail is then
stored on the mail server.
00-FF (0 to 1024 KB: HEX)
NOTE: The hexadecimal number you enter is multiplied by 4 KB to determine the
amount of memory.
B750
CÓPIA NÃO CONTROLADA
58
CÓPIA NÃO CONTROLADA
SP No. 1-102-005
COMMENTS
SP No. 1-102-006
COMMENTS
SP No. 1-102-007
SP No. 1-102-008
SP No. 1-102-009
COMMENTS
SM