Laser Beam Pitch Adjustment - Ricoh B156 Service Manual

LASER UNIT

Laser Beam Pitch Adjustment

1. Print out the test pattern with
SP5-955-1, then select pattern
15 ( 5.1.3).
2. Check if vertical black stripes
can be seen.
a) If stripes cannot be seen
(Figure 2), laser beam
pitch adjustment is not
required.
b) If stripes can be seen
(Figure 1), laser beam
pitch adjustment is
required. Go on to the
next step.
3. To adjust the laser beam pitch,
tighten or loosen the screw [A]
on the LD unit holder.
4. Print out the test pattern with
SP5-955-1 and select pattern
15.
5. Repeat steps 2 through 4 until
the black stripes disappear
(Figure 2).
6. After you complete the test
prints, set SP 5-955-1 to 0.
B156/B220
CÓPIA NÃO CONTROLADA
B156R240.WMF
3-18
CÓPIA NÃO CONTROLADA
Feed direction
[A]
B156R242.WMF
SM