Removal And Installation Of The Projector Covers; Removal Of The - Barco HDF W series Installation Manual

16. REMOVAL AND INSTALLATION OF THE PROJECTOR
COVERS
About this chapter
Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with
detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
W
ARNING
one of the covers.
16.1 Removal of the front cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the front cover
1. Remove the lens. See "Lens removal", page 25.
2. Remove the rubber dust ring from the lens holder.
3. Release the captive screw at the middle bottom of the front cover, using a flat screw driver. (image 16-1)
4. Remove the front cover from the projector as follows:
a) standing in front of the projector, pull the right side of the front cover toward you until the latches release (left side is hinged)
b) then slide the front cover to the right to release it from the hinging points. (image 16-2)
Image 16-1
Captive screw
R5905158 HDF W SERIES 10/07/2012
:
Always switch off the projector and unplug the power cord at the projector side before removing
:
This procedure may only be performed by qualified technical service personnel.

16. Removal and installation of the projector covers

223