Barco HDF W series Installation Manual page 39

on the size of the truss installation. The rigging clamps (C) can be attached to those rigging points, which allows an easy and fast
physical setup of the projector in a hanging configuration.
Image 3-38
Rigging points
Necessary tools
• 24 mm open ended spanner.
• 17 mm open ended spanner.
Necessary parts
• Four rigging clamps (R820411).
• Safety chains.
How to install and to use the rigging clamps ?
1. Measure the distance, center tube as reference, between the two used support bars of the truss. (image 3-39)
2. Turn the projector upside down and slide the rigging points on there place in the slots, according the measured distance and
secure this position. To release the nuts of the rigging points use a 24 mm open ended spanner. Ensure that the rigging points
are symmetrically lined up, so that the projector will hang in balance. (image 3-40)
Warning: Be careful while working with heavy loads.
Warning: Always secure the rigging points after adjustment.
3. Turn in the rigging clamps (A) into the rigging points using a 17 mm open ended spanner and secure the rigging clamps by turning
the safety nut (B) on the rigging clamp against the rigging point using a 17 mm open ended spanner. (image 3-41)
Warning: Always use four (4) rigging points, equally spread, to suspend the projector.
4. Place all four rigging clamps in open position as illustrated. (image 3-42)
5. Place the projector (upside down) under the truss installation and lower the truss until the support bars of the truss are nearby
the rigging clamps mounted on the projector. (image 3-43)
6. Lift up the projector and hook the four rigging clamps over the support bars of the truss.
7. Lock all four rigging clamps.
8. Install a safety chain (S) around both sides of the carrying handle and around the truss. (image 3-44)
Warning: Install the safety chain in that way that the projector cannot drop more than 20 cm.
9. Lift up the truss with attached projector to the desired height.
X mm
Image 3-39
R5905158 HDF W SERIES 10/07/2012
A
B
3. Physical installation
C
35