Image File Services; Files And File Manipulations; Manual Load File - Barco HDF W series Installation Manual

9. Image
9.6

Image File Services

9.6.1 Files and file manipulations
Connecting a new source.
Source dependent adjustments like image settings, aspect ratio and timings are stored in a dedicated image file.
Before using a new source, a correct image file has to be installed. The projector's memory contains a list of files corresponding to
the most used sources. When the new source corresponds with one of these files, the file can be loaded and saved for future use.
When there is a little difference, the file can also be loaded and then edited until the source specs are reached.
VESA standards and video standards are pre-programmed.
Possible file Manipulations
The following file manipulations are possible :
• Load : load the settings of a selected file for the current selected source of the active window (main or PiP)
• Rename : renaming a file.
• Delete : deleting a file (only custom files)
• Delete all : delete all custom files
• Options : way of loading a file when a source is selected.
9.6.2 Manual Load file
How to load
1. Press Menu to activate the menus and select Image → Image File Services → Manual Load. (image 9-55, image 9-56, im-
age 9-57)
2. Press ENTER to select.
Depending on the File Load Filter setting a full list or a list fitting the selected source is displayed.
When staying for at least 3 seconds on the same file selection after scrolling through the list of image files a pre-load is started.
(image 9-58)
3. Use the ▲ or ▼ key to select the desired file and press ENTER to load this file.
Image 9-55
Main menu, Image
98
Image 9-56
Image, image file services
R5905158 HDF W SERIES 10/07/2012