Nokia 9000i Service Manual page 228

RAE/RAK–1N
Service Software
3.6.5 – Program Flash From File
This menu provides means to program the PDA Flash memory from a file
on the disk in the host to all the targets in parallel.
Start Physical Address default: 3C00000h
Start Relative Address default: 000000h Range: 000000h – 1FFFFFh
If the Start Physical Address is set to 3E00000h the maximum Start
Relative Address may not be greater than 1FFBFFh
The output from the target shows the following:
whether the command was parsed successfully
whether the buffer filling was successful
whether the Flash programming was successful
3.6.6 – Calculate Checksum
By choosing this menu, the target calculates a 32–bit checksum of the
ROM between the given physical addresses.
User options are:
Start Physical Address default: 3C00000h
End Physical Address default: 3FFFBFFh
The output from the target shows the following:
whether the commands were parsed successfully
Calculated 32–bit checksum
3.7 – JTAG Flashing
This menu provides means to program the PDA Flash memory from a file
on the disk using the JTAG interface of the target.
The output from the target shows the following:
whether the command was parsed successfully
whether the commands in the configuration file were executed
successfully
Page 7– 70
After Sales
Technical Documentation
Range: 3A00000h
3C00000h
3E00000h
Range: 3A00000h
3FFFBFFh
Range: 3A00000h
3FFFBFFh
Amendment 1 04/97