Nokia 9000i Service Manual page 174

RAE/RAK–1N
Service Software
1 – PC Setup
When Save Current Setup is selected the program asks for a setup file
name. The saved information will include all parameters shown below:
Command line parameter value for COM–port selection
– RF Controls menu
All selections
– Call Simulation
All selections which are not the same as in the RF Controls menu
– Tuning parameters (PC default values; no effect on EEPROM
values)
TX power coefficients
Power connection diagram
– Run MCU Self–tests
All selections
The following selections are not saved to the setup file:
– Values which are asked from MS
AFC value
– Main Menu
Phone Mode (Start value = Normal)
– PC Setup menu
Default name for setup file
(Start value = RAE_1.CON)
– Internal audio loop:
Page 7– 16
After Sales
Technical Documentation
Amendment 1 04/97