Nokia 9000i Service Manual page 205

After Sales
Technical Documentation
PDA Menu Commands
Introduction
Upon selection, the service software will try to establish a communications
link to the PDA module via the second serial port (if fitted) or alternatively
when the DLR–1 connector is attached to the first serial port in place of
the MBUS. Once a link is established between the service software and
the PDA, further tests may be carried out.
When 'PDA Functions' is selected, the serial port must be chosen, but
before doing this , disconnect the power supply *(see note 1).
Select either 1 or 2 *(see note 2)and press enter to display the 'Pinging
Target' message as shown overleaf.
Amendment 1 04/97
RAE/RAK–1N
Service Software
Page 7– 47