Nokia 9000i Service Manual page 218

RAE/RAK–1N
Service Software
7.3 – Test Flash
Enabling this choice adds the Flash test to be included to the test
sequence. The first block of each Flash device is checksummed, then it's
read and saved on a disk in the service software. After the block is saved,
the physical block is erased, and then programmed from the file where the
contents was saved.
After programming, the block is checksummed and the result is compared
to the original one. If the checksums are equal with each block, the test is
considered successful. The test is performed with the default parameters
shown below:
Filename
Start Physical Address
Start Relative Address
End Physical Address
End Relative Address
Start Physical Address
Start Relative Address
End Physical Address
End Relative Address
Start Physical Address
Start Relative Address
End Physical Address
End Relative Address
The output from the target shows the following:
whether the test was successful
7.4 – LCD Test
Enabling this choice adds the LCD test to be included to the test
sequence. The test is performed with default parameters as follows:
Contrast default:
Test Pattern default:
Page 7– 60
Technical Documentation
default:Flashtest.bin
default:3A00000h
default:000000h
default:3A00000h
default:00FFFFh
default:3C00000h
default:000000h
default:3C00000h
default:00FFFFh
default:3E00000h
default:000000h
default:3E00000h
default:00FFFFh
128
Gray
Gray inverted
Matrix
Matrix inverted
Chess
Chess inverted
All ON
All OFF
Vision
Vision inverted
Amendment 1 04/97
After Sales