Fuji Xerox DocuPrint 2050 User Manual page 11

Do not unplug or replug the machine while
it is on. Unplugging a live connector can
deform the plug and cause fire.
Stop operation immediately if your machine
produces smoke, excessive heat, unusual
noise, or smell, or if water or foreign object
(e.g. metal strip, liquid) enters the machine.
These conditions can cause fire.
Immediately switch off and unplug the
machine, and contact dealers.
To prevent fire or electric shock, follow the
instructions below based on your machine
configuration. If in doubt, contact dealers.
• If your machine is a 220 - 240 V model,
there is no need to attach a separate
earth line since the earth connection is
incorporated in the power line. Plug it into
a properly rated outlet.
• If your machine is a 100 or 110 V model,
use the green earth wire bundled with the
power cord, located at the rear of the
machine.
The earth wire must be connected to one of
the following conductors:
- Earth terminal of the specified power
outlet
- A piece of copper buried in the earth 650
mm or deeper
- Earth terminal with Class D* earthing.
*Class D is the regulation for Japan only.
Never connect the earth wire to any of the
following:
• Gas pipe, which can be ignited and
explode
• Telephone line earth wire or lightning
rod, which can draw an excessive
electric current if hit by lightning
• Water faucet or pipe whose electrical
conductivity is broken by a non-metal
part
When unplugging the machine, grasp the
plug instead of the cord. Forcibly pulling on
a cord can damage it and cause fire or
electric shock.
Be sure to switch off the power first, and
then unplug before accessing the interior of
the machine for cleaning, maintenance, or
fault clearance. Access to a live machine's
interior can cause electric shock.
Once a month, unplug the machine and
check the power cord for the following:
• The power cord is plugged firmly into a
receptacle.
• The plug is not excessively heated,
rusted, or bent.
• The plug and receptacle are free of dust.
• The cord is not cracked or frayed.
If you notice any unusual conditions,
contact dealers.
When the machine is not used over an
extended period of time, switch it off and
unplug it. If an unused machine is left
connected to a power source for a long
period, degraded insulation can cause
electric shock, current leakage, or fire.
Switch off the machine before connecting
the interface cable and optional product.
Connecting the cable or optional product
with a live machine can cause electric
shock.
If the power cord is broken or insulated wires
are exposed, ask dealers for a replacement.
Using a damaged cord can cause fire or
electric shocks.
11
Safety Notes