Send The Escape Sequence (+++) In Modem Mode; Show Ip Addr After 'Ring; Auto Increment Source Port; Remote Ip Address - Lantronix UDS1100 User Manual

Modem Mode
Command
ATH
ATS0=n
ATEn
ATVn
Note: The unit recognizes these AT commands as single commands such as
ATE0 or ATV1; it does not recognize compound commands such as ATE0V.

Send the Escape Sequence (+++) in Modem Mode

Disable or enable the UDS1100's ability to send the escape sequence. The default
setting is Y (Yes) (send the escape sequence).

Show IP addr after 'RING'

Disable or enable the UDS's ability to show the IP address after RING in Modem
Mode. The default is Y (Yes), to show the IP address.

Auto Increment Source Port

Y (Yes) auto increment the source port. The UDS1100 increments the port number
used with each new connection.

Remote IP Address

This is the destination IP address used with an outgoing connection.
Note: This option does not display when Hostlist is enabled from the
ConnectMode prompt (see
UDS1100 User Guide
Function
Hangs up the connection (Entered as +++ATH ).
Enables or disables connections from the network going to the serial
port.
n=0 disables the ability to make a connection from the network to the
serial port.
n=1-9 enables the ability to make a connection from the network to
the serial port.
n>1-9 is invalid.
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Send '+++' in Modem Mode (Y) ? _
Auto increment source port (N) ? _
Remote IP Address : (000) (000) (000) (000)_
Connect Mode
7: Setup Mode: Channel Configuration
on page 44 for more information).
51