Modem Mode Command
ATDTx.x.x.x,pppp,
ATDTx.x.x.x/pppp, or
ATDTx.x.x.x:pppp
ATDTx.x.x.x
ATD0.0.0.0
ATD or ATDT
ATDx.x.x.x
ATH
ATS0=n
ATEn
ATVn
Note:
The unit recognizes these AT commands as single commands such as ATE0 or ATV1;
it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode
Send '+++' in Modem Mode (Y) ? _
XPort® Device Server User Guide
7: 59BSetup Mode: Channel Configuration
Table 7-9. Modem Mode Commands
Function
Makes a connection to an IP address (x.x.x.x) and a remote port
number (pppp).
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
Forces the unit into Monitor Mode if a remote IP address and port
number are defined within the unit.
Forces the unit into Monitor Mode if a remote IP address and port
number are not defined within the unit.
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
Hangs up the connection (Entered as +++ATH ).
Enables or disables connections from the network going to the serial
port.
n=0 disables the ability to make a connection from the network to the
serial port.
n=1-9 enables the ability to make a connection from the network to
the serial port.
n>1-9 is invalid.
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
57