Monitor Setting Selection(D9215 To D9218) - Mitsubishi Electric FR - F700 Programming Manual

1.10.8 Monitor setting selection(D9215 to D9218)

Set the names and units of monitored items for each of D9216, D9217, and D9218
using the PR command. (Refer to page 193.)
To display the names and the units of the monitored items, which are set by D9216 to
D9218, on FR-PU07-01, set "40, 41, or 42" in Pr.774 to Pr.776. (Refer to the Instruction
Manual of the inverter for the details of Pr.774 to Pr.776.)
Device
D9216
D9217
D9218
Set D9215 as shown below to display the monitored values, which are set by D9216 to
D9218, with decimal points.
<Setting of D9215>
B15 B12B11 B8B7
* The bits other than the ones above are ignored.
<Displayed decimal point setting>
bn+1 bn
0 0
0 1
1 0
1 1
Setting example:
1. To display the D9216 monitor without a decimal point in the first monitor
• Set H0000 in D9215.
• Set "40" in Pr.774.
2. To display the D9216 monitor in 0.1 increments in the first monitor and the D9218
monitor in 0.001 increments in the second monitor
• Set H3100 in D9215.
• Set "40" in Pr.774 and "42" in Pr.775.
Monitored item
User monitor 1
User monitor 2
User monitor 3
B4B3 B0
Select the displayed decimal point for the D9216 monitor.
Select the displayed decimal point for the D9217 monitor.
Select the displayed decimal point for the D9218 monitor.
Unit
1 increment
(without decimal point)
0.1 increment
0.01 increment
0.001 increment
Inverter status monitoring, special registers
Pr.774 to Pr.776 setting
40
41
42
for control
1
39