Attach Oscillator Arm (To Column Mount); Attach Lower Yoke (To Main Fan Unit) - BIG ASS FANS Pivot 180 Installation Manual

1. Attach oscillator arm (to column mount)

To prevent damage to the motor the oscillator arm must be mounted parallel to the floor with the motor in the
"downward" position!
Insert the (2) plastic spacers on the inner sides of the plates on the front column mount. Insert the oscillator arm between the column
mount plates and attach it with the bolt, washer, and Nylock nut as shown.
Adjust the oscillator arm to the desired horizontal position, and then secure the
position with the lock washer and screw. Tighten the bolt to 40 ft·lb (54.2 N·m)
using a torque wrench with a 3/4" socket.
Oscillator Arm Hardware (BAF-supplied):
a. (1) 1/2"-13 x 5'' GR 8 Bolt
b. (2) 1/2'' Flat Washer
c. (1) 1/2"-13 Nylock Nut
d. (1) 10-34 OD Lock Washer
e. (1) 10-32 Screw
Note: Be sure obstructions will not
interfere with the placement of the
oscillator arm and fan movement.

2. Attach lower yoke (to main fan unit)

CAUTION: Position the main fan unit so that the motor
is pointing upward. The motor should never be lower
than the gearbox. This will provide proper lubrication to
the gearbox.
Attach the lower yoke to the motor frame with the Main Fan Unit
Hardware as shown. Tighten the bolts to 40 ft·lb (54.2 N·m)
using a torque wrench with a 3/4" socket.
Main Fan Unit Hardware (BAF-supplied):
a. (4) 1/2-13 x 1-3/4" GR 8 Bolt
b. (8) 1/2'' Flat Washer
c. (4) 1/2-13 Nylock Nut
PIVOT™ 180
Hanging the Fan
Oscillator
WWW.BIGASSFANS.COM ©2011 DELTA T CORP.
Plastic
Spacers
Arm
d
e
ALL RIGHTS RESERVED
17
a
b
b
c
a
b
b
c