Table of Contents
Advertisement
WARNING: Immediately disconnect the fan from power if there is any sudden increase in vibration!
CAUTION: Never make swivel and/or rotational adjustments while the fan is connected to power!
WARNING: The fan should never be operated with loose mounting or adjustment hardware!
Mechanical installation
The Sweat Bee® is supplied standard with a direct mount� Optionally, a wall/column mount can be purchased to
install the fan on a wall or vertical column� A yoke mount can be purchased to install the fan to an I-beam or bar
joists� A pedestal can also be purchased to elevate the fan and provide mobility�
The Sweat Bee must be positioned in a location that is free of foreign objects that may interfere with the fan� The
following instructions are merely a recommendation for mounting the Sweat Bee� Consult a structural engineer to
determine the best method and hardware for mounting your fan.
Direct mount (standard)
The fan yoke should be bolted to a horizontal structural member, such as a truss
or I-beam� Do not directly bolt the fan yoke to a vertical beam or wall� The wall/
column mount must be used in these applications� The fan can be swiveled up
or down ±40° from the center�
To swivel the fan, disconnect the fan from power, and then loosen the two swivel
adjustment bolts located on the sides of the fan housing� Reposition the fan and
securely tighten the hardware� Ensure no strain is put on the electrical wiring for
the motor when adjusting the fan position� Proceed to safety cable installation
on page 7�
Yoke mount (optional)
If installing the fan to an I-beam or bar joists with an extension tube, follow the installation instructions provided
with the Yoke Mount kit�
Wall/Column mount (optional)
The wall/column mount allows the Sweat Bee to be mounted to a wall or column� The mount must be bolted or
welded to a vertical beam and mounted so that the fan is on the topside of the bracket, not hanging downward�
The fan housing can be swiveled up or down ±40° from center and rotated 360° as long as it does not strain the
electrical wiring for the motor�
To adjust the fan, disconnect the fan from power, and then loosen the appropriate
hardware� Reposition the fan and securely tighten the hardware� Note: All hardware
used to secure the wall/column mount to the wall or column is customer-supplied
and must be of sufficient strength to support the weight of the fan. Proceed to safety
cable installation on page 7�
INSTALLATION
877-BIG-FANS
© 2012 DELTA T CORP.
ALL RIGHTS RESERVED
003489-01
REV. I
5
Advertisement
Table of Contents
