Installing The Electronic Programming Module (Epm) - BIG ASS FANS Pivot 180 Installation Manual

28

Installing the Electronic Programming Module (EPM)

If hanging multiple fans, ensure to install the exact EPM included in each fan's packaging. EPMs are not
interchangeable!
WARNING: Install the EPM prior to applying power to the fan controller!
The EPM contains all programming information specific to fan operation. It must be installed prior to applying power to the fan controller.
This module is provided as part of the fan's accessory kit.
To install the EPM, disconnect the fan from power (refer to the position of the disconnect switch below). Insert the EPM in the location
shown below. Note: The EPM module can only be inserted one way. Do not force it!
Electronic
Programming
Module
PIVOT™ 180
Electrical Installation (cont.)
WWW.BIGASSFANS.COM ©2011 DELTA T CORP.
WARNING
DO NOT USE THIS
DISCONNECT TO
START AND STOP THE
FAN. PERMANENT
DAMAGE WILL
RESULT! SCA M E SCA M E
AUTO FWD
REV
M
R F
1 2 5 6 1 2 5 6 25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
PE
U V W L1
/T1 /T2 /T3
BROWN
ORANGE
ALL RIGHTS RESERVED
RUN
STOP
L1
L2
L2 L3
L3
YELLOW