BIG ASS FANS Pivot 180 Installation Manual page 36

30
Wiring: 100–125V/200–250V single-phase fan controllers
WARNING: Wait three minutes after disconnecting before servicing!
WARNING: Improper installation can cause electric shock or damage to the motor and controller. A qualified electrician
should perform the installation.
The diagram below shows wiring options for a 100–125V/200–250V 1Φ fan controller. See "Power Requirements for Fan Controllers"
on page 25 for detailed power requirements.
Wiring for 200–250V 1Φ, 50/60Hz fan controllers
The neutral terminal is not used when wiring the fan
controller for 200–250V 1Φ. A disconnect and EMI
filter are included with this fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via
a dedicated circuit breaker or properly fused
disconnect!
Optional wiring for 100–125V 1Φ, 50/60Hz fan controllers
The L2 terminal is not used when wiring the fan
controller for 100–125V 1Φ. A disconnect is included
with this fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via
a dedicated circuit breaker or properly fused
disconnect!
PIVOT™ 180
Electrical Installation (cont.)
WWW.BIGASSFANS.COM ©2011 DELTA T CORP.
1 2 5 6 1 2 5 6 25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
PE
U V W
/T1 /T2 /T3
AC Input Wiring
2W plus GND
1 2 5 6 1 2 5 6 25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
PE
U V W
/T1 /T2 /T3
AC Input Wiring
2W plus GND
ALL RIGHTS RESERVED
L1
L2
L1 L2 L3
N
Motor Output Wiring
3W plus GND
L1
L2
L1 L2 L3
N
Motor Output Wiring
3W plus GND