BIG ASS FANS Pivot 180 Installation Manual page 37

Wiring: 200–250V three-phase fan controllers
WARNING: Wait three minutes after disconnecting before servicing!
WARNING: Improper installation can cause electric shock or damage to the motor and controller. A qualified electrician
should perform the installation.
The diagram below shows wiring options for a 200–250V 3Φ fan controller. See "Power Requirements for Fan Controllers" on page 25
for detailed power requirements.
Wiring for 200–250V 3Φ, 50/60Hz fan controllers
A disconnect is included with the fan controller for
200–250V 3Φ. An EMI filter is not included with this
fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via
a dedicated circuit breaker or properly fused
disconnect!
Optional 1Φ wiring for 200–250V 3Φ, 50/60Hz controllers
The L3 terminal is not used when wiring the fan
controller for 200–250V 1Φ. A disconnect is included
with the fan controller. An EMI filter is not included with
this fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via a
dedicated circuit breaker or properly fused disconnect!
PIVOT™ 180
Electrical Installation (cont.)
WWW.BIGASSFANS.COM ©2011 DELTA T CORP.
1 2 5 6 1 2 5 6 25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
PE
U V W L1
/T1 /T2 /T3
AC Input Wiring
3W plus GND
1 2 5 6 1 2 5 6 25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
PE
U V W L1
/T1 /T2 /T3
AC Input Wiring
2W plus GND
ALL RIGHTS RESERVED
31
L1
L2
L2 L3
L3
Motor Output Wiring
3W plus GND
L1
L2
L2 L3
L3
Motor Output Wiring
3W plus GND