Secure Safety Cable (To Lower Yoke); Attach Center Cap - BIG ASS FANS Pivot 180 Installation Manual

4. Secure safety cable (to lower yoke)

Note: Fan angle adjustment must be complete before securing the safety cable.
Select a bolt hole on the upper half of the lower yoke mount from which to attach the safety cable spacer.
Place the loose, looped end of the safety cable around the safety cable spacer on the lower yoke mount, and then secure the spacer
with the Safety Cable Spacer Hardware, leaving a little slack in the cable to accommodate fan movement. Tighten the bolt to 40 ft·lb
(54.2 N·m).
Safety Cable Spacer Hardware (BAF-supplied):
a. (1) 1/2-13 x 4-1/2" Hex Head Bolt
b. (4) 1/2" Flat Washer
c. (2) Safety Cable Spacer
d. (1) 1/2-13 Nylock Nut (not pictured)
b
a

5. Attach center cap

Snap center cap onto the bottom of the main fan unit.
Proceed to "Installing Airfoils" on the following page.
PIVOT™ 180
Hanging the Fan (cont.)
c b
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. ALL RIGHTS RESERVED
19