Fenix SM2000 Operation Manual page 43

Thermal printer
Table of Contents

Advertisement

FENIX IMVICO
n
0, 48
1,49
2, 50
m specifies a test pattern.
m
1, 49
2, 50
3,51
[Notes]
This command is enabled only when processed at the beginning of a line.
The printer cuts the paper at the end of the test print.
GS B n
[Name]
Turn white/black reverse printing mode
[Format]
ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description]
Turns on or off white/black reverse printing mode.
When the LSB of n is 0, white/black reverse mode is turned off.
When the LSB of n is 1, white/black reverse mode is turned on.
[Notes]
Only the lowest bit of n is valid.
When white/black reverse printing mode is on, it also applied to character spacing set by
ESC SP.
This command does not affect bit image, user-defined bit image, bar code and HRI
characters.
This command does not affect the space between lines.
White/black reverse mode has a higher priority than underline mode. Even if underline
mode is on, it is disabled (but not cancelled) when white/black reverse mode is selected.
[Default]
n = 0
GS H n
[Name]
Select printing position for HRI characters
[Format]
ASCII
Hex
Decimal
[Range]
n = 0/3
[Description]
Selects the printing position of HRI characters when printing a bar code.
n selects the printing position as follows:
[Notes]
HRI indicates Human Readable Interpretation.
HRI characters are printed using the font specified by GS f.
[Default]
n = 0
GS f, GS k
[Reference]
Paper
Basic test
Complete test
Test pattern
Hexadecimal dump
Printer status print
Rolling pattern print
GS
B
1D
42
29
66
GS
H
1D
48
29
72
n
Printing position
0
Not printed
1
Above the bar code
2
Below the bar code
3
Both above and below the code bar
n
n
n
n
n
n
SM2000 OPERATION MANUAL
43/65

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SM2000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents