Fenix SM2000 Operation Manual page 41

FENIX IMVICO
ESC c 5 n
[Name] Enable/disable panel button
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Enables or disables the panel buttons.
When the LSB of n is 0, the panel button is enabled.
When the LSB of n is 1, the panel button is disabled.
[Notes]
•
Only the lowest bit of n is valid.
•
When the panel button is disabled, not is usable when the printer cover is closed.
•
In this printer, the panel button is the FEED button.
n = 0
[Default]
ESC d n
[Name] Print and feed n lines
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Prints the data in the print buffer and feeds n lines.
[Notes]
•
This command sets the print starting position to the beginning of the line.
•
This command does not affect the line spacing set by ESC 2 or ESC 3.
•
The maximum paper feed amount is 1016 mm. If the paper feed amount (n x line
spacing) of more than 1016 mm is specified, the printer feeds the paper only 1016 mm.
ESC 2, ESC 3
[Reference]
ESC p m t1 t2
[Name] Generate pulse
[Format] ASCII
Hex
Decimal
[Range] m = 0, 1, 48, 49
0 ≤ t1≤ 255, 0 ≤ t2 ≤ 255
[Description] Outputs the pulse specified by t1 and t2 to connector pin m as follows:
m
0, 48
1, 49
[Notes]
•
The pulse ON time is [t1 x 2 ms] and the OFF time is [t2 x 2 ms].
ESC c 5
1B 63 35
27 99 53
ESC d n
1B 64 n
27 100 n
ESC p m
1B 70 m
27 112 m
Connector pin
Drawer kick-out connector pin 2.
Drawer kick-out connector pin 5.
SM2000 OPERATION MANUAL
n
n
n
t1 t2
t1 t2
t1 t2
41/65