Fenix SM2000 Operation Manual page 40

FENIX IMVICO
ESC c 3 n
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Selects the paper sensor(s) to output paper end signals
Each bit of n is used as follows:
Bit
0
1
2
3
4-7
[Notes]
•
The command is available only with a parallel interface and is ignored with a serial interface.
•
It is possible to select multiple sensors to output signals. Then, if any of the sensors detects
a paper end, the paper end signal is output.
•
Sensor is switched when executing this command. The paper end signal switching be
delayed depending on the receive buffer state.
•
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals
•
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor
outputting paper-end signals.
•
When all the sensors are disabled, the paper end signal always outputs a paper present
status.
[Default] n = 12
ESC c 4 n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Selects the paper sensor(s) used to stop printing when a paper-end is detected, using n
as follows:
Bit OFF / ON
0 OFF
ON
1 OFF
ON
2-7 -
[Notes]
•
When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.
•
When the paper roll sensor detects a paper-end, the printer goes offline after printing stops.
•
When either bit 0 or 1 is on, the printer selects the paper roll near-end sensor for the paper
sensor to stop printing.
[Default] n = 0
ESC c
1B 63
27 99
OFF / ON Hex
OFF 00 Paper roll near-end sensor disabled
ON 01 Paper roll near-end sensor enabled
OFF 00 Paper roll near-end sensor disabled
ON 02 Paper roll near-end sensor enabled
OFF 00 Paper roll end sensor disabled
ON 04 Paper roll end sensor enabled
OFF 00 Paper roll end sensor disabled
ON 08 Paper roll end sensor enabled
- - Undefined
ESC c
1B 63
27 99
Hex Decimal
00 0
01 1
00 0
02 2
- -
3 n
n
33
51 n
Function
4 n
34 n
52 n
Function
Paper roll near end sensor disabled.
Paper roll near end sensor enabled.
Paper roll near end sensor disabled.
Paper roll near end sensor enabled.
Undefined.
SM2000 OPERATION MANUAL
40/65