Fenix SM2000 Operation Manual page 38

FENIX IMVICO
ESC E n
[Name] Turn emphasized mode on/off
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Turns emphasized mode on or off
When the LSB of n is 0, emphasized mode is turned off.
When the LSB of n is 1, emphasized mode is turned on.
[Notes]
•
Only the least significant bit of n is enabled.
•
This command and ESC ! turn on and off emphasized mode in the same way. Be careful
when this command is used with ESC !.
[Default] n = 0
[Reference] ESC !, ESC G
ESC G n
[Name] Turn on/off double-strike mode
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Turns double-strike mode on or off.
When the LSB of n is 0, double-strike mode is turned off.
When the LSB of n is 1, double-strike mode is turned on.
[Notes]
•
Only the lowest bit of n is enabled.
•
Printer output is the same in double-strike mode and in emphasized mode.
[Default] n = 0
[Reference] ESC E
ESC J n
[Name] Print and feed paper
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Prints the data in the print buffer and feeds the paper [n x horizontal or vertical motion
units].
[Notes]
•
After printing is completed, this command sets the print starting position to the beginning of
the line.
•
The paper feed amount set by this command does not affect the values set by ESC 2 or
ESC 3.
•
In standard mode, the printer uses the vertical motion unit (y).
•
The maximum line spacing is 1016mm. When the setting value exceeds the maximum,
it is converted to the maximum automatically.
ESC E n
n
1B 45
27 69 n
ESC G n
1B 47 n
27 71 n
ESC J n
1B 4A n
27 74 n
SM2000 OPERATION MANUAL
38/65