Application; Information On The Product; Type Plate; Information On The Documentation - Soyer BMK-12 W Operating Instructions Manual

BMK-12 W
1.2

Application

The BMK-12 W SOYER stud welder for short-cycle drawn arc welding allows SOYER
threaded studs as per DIN EN ISO 13918 and ranging from M3 – M12 or Ø 2 – 11mm
(studs, shear connectors, concrete anchors) made of plain, stainless and heat-
resistant steel to be welded on different workpieces (sheets, tubes, steel girders etc.).
Usually round pins with or without thread are welded. You may also weld fasteners
with different cross-sectional shapes. For this purpose, however, special stud holders
and ceramic ferrules or gas shrouds are required.
With the BMK-12 W SOYER stud welder it is also possible to weld studs of other
metallic materials than steel. It is, however, necessary to first carry out experimental
welds and to inspect them.
If you need consultation or assistance in solving problems, please contact either our
parent company or our field engineers.
1.3

Information on the product

Manufacturer Heinz Soyer Bolzenschweißtechnik GmbH
Etterschlag
Inninger Straße 14
D-82237 Wörthsee
Telephone +49 (0) 8153-885-0
Telefax
www.soyer.de
Product designation BMK-12 W Stud Welder
Country of origin
1.4

Type plate

The type plate is located on the rear side of the stud welder. It contains the following
information:
• Manufacturer's name
• Address of manufacturer or agency
• Country of origin
• Product designation
• Mains connection values
• Performance data
• Production number / year of construction
1.5

Information on the documentation

The following operating instructions are supplied with the BMK-12 W stud welder:
• Operating instructions for BMK-12 W stud welder
Order no.: P00228
For repeat-orders please contact your responsible service office or our parent
company. Please refer to chapter 1.6.
+49 (0) 8153-8030
Germany
13