3
3.10
Setting Job During Warmup
Select copy conditions and start scanning during warmup, so that the ma-
chine may start printing immediately the machine engine is ready.
To scan the original during warmup
0 The machine starts warming up under the following conditions:
The sub power switch is turned on. (See page 2-29.)
[Power Save] is pressed to release the Sleep mode. (See page 2-37.)
Weekly Timer mode is interrupted with a password entered. (See
page 2-40.)
1
Check that the message "Now warming up. Ready to scan." is dis-
played in the message area of the Basic Screen.
–
The LED of the [Start] key will lights in green.
2
Position the original.
3
Set the desired copy conditions, and enter the print quantity.
4
Press [Start] on the control panel.
The original will be scanned into memory, and a print job will be on
standby.
3-62
Basic Copy Operations
bizhub 500/420