Ness PowerPlex EDR400 Instruction Manual page 58

Upper Panel
Upgrade – To remote upgrade the system. Click on the button and follow
the procedures shown on the screen for remote upgrading. (Note.3)
Download – To download the configuration files from
Upload – To upload the configuration files to
configuration file is uploaded, you must reboot the
on the
from the remote PC.
Guide – To view the introduction of how to operate the remote browser.
About – To view the information about
Right Panel
W1 ~ W4 Camera / Type – To select the display cameras for Window 1 ~
Window 4. Click on the down arrow button to select the desired
camera for each window, and then select Live or Play from the
options below for Live Video or Image Playback for each
window. Click on the Submit button while the setting is
completed.
PTZ - Click on the PTZ button, a PTZ control panel will be shown on
the screen. Select the camera number, the other control functions
are the same as on
Control Functions. Click on PTZ button again to hide the PTZ
control panel.
Playback Date/Time – To set the searching date/time for Image Playback.
Enter the desired date and time in the proper columns, click on
the Submit button to change the setting. The Playback
Date/Time searching is based on
please enter the local date/time for searching if there's time
difference between local and remote end.
Alarm Out – To enable/disable the alarm out remotely.
Lower Panel
–
–
/ –
While the camera and date/time settings for image playback have been
submitted, operate the following buttons for video playback.
Administrator's Guide and Operating Instructions
button at the lower panel to reboot the
e
DR400. Please refer to Chapter 7 for PTZ
e
To reboot the DR400 system remotely.
To view the log file of
To switch between quad screen and full screen mode.
54
e
DR400.
e
DR400. After the
e
DR400 system. Click
e
DR400 system
e
DR400.
e
DR400 system clock
e
DR400.