Ness PowerPlex EDR400 Instruction Manual page 26

Record Audio – To enable audio recording function while the alarm
action is triggered.
Any Key To Stop – When the Alarm Action is triggered, the internal
buzzer and Alarm Out relay may be activated. If you want to stop
those actions by pressing any key or moving/clicking the mouse,
please check this item.
Send Mail - To activate the e-mail notification function or not when
the Alarm Action is triggered. The e-mail will be sent to the defined
receivers with an attached file, which contains the video graphic file
of the alarm triggered moment. (Note 3) However, if the alarm
action happened during the post record time from the previous
triggered alarm, there will be no notification sending for the
corresponding action. Please refer to Chapter 6.15 for e-mail
notification setting.
Network Alarm (Reserved function)
SMS (Reserved function)
Note 1: When the Alarm Input that triggered the Alarm Action returns to normal,
the internal buzzer and the corresponding Alarm Output will return to
normal immediately.
Note 2: The processing power for the system is 25 FPS for PAL and 30 FPS for
NTSC. So, if the total configured recording rate for all the cameras is 5
FPS, intensive recording means that the actual FPS for the Pre-record time
for the Focus Camera is 5 times (for PAL) or 6 times (for NTSC) the
configured normal recording rate for the Focus Camera. The formula is:
Fp = Fn x 25 / Ft for PAL, Fp = Fn x 30 / Ft for NTSC
Fp: Pre-record FPS, Fn: normal FPS for Camera n, Ft: Total configured FPS.
Note 3: For general user, the attached video graphic file will be in a QCIF GIF file
format (176x120 for NTSC, 176x144 for PAL). For WAP user, the file will
be in a Sub-QCIF file format (88x60 for NTSC, 88x72 for PAL).
Administrator's Guide and Operating Instructions
22