Ness PowerPlex EDR400 Instruction Manual page 45

- Mail Setup
To define the setting of the E-mail notification function. The
following dialog box will be shown on the screen after the Mail item
is selected.
SMTP server – Enter the address and port number for the SMTP
Server. The address can be either domain name or IP address,
and the port number for SMTP server is normally 25. If the
SMTP server requires authentication, check the item box and
enter the effective name and password below.
Sender – Enter the sender's e-mail address which you would like
to show on the outgoing notification.
E-mail receiver – The system can send e-mail notification to up
to 8 receivers for each action. Enter the e-mail addresses in
#1 ~ #8 columns. For WAP message, check the box on the right
of the e-mail address.
- Network Alarm (Reserved Function)
- SMS (Reserved Function)
Administrator's Guide and Operating Instructions
41