Ness PowerPlex EDR400 Instruction Manual page 49

Administrator's Guide and Operating Instructions
Auto Pan – To enable Auto Pan function. Select the speed (high,
Medium or Low) from the above column by using the down
arrow button, then click on Auto Pan button to start. The
camera will run between the defined start and end position.
Click on Auto Pan button again to stop running.
Sequence – To enable Sequence Mode. In sequence Mode, the
camera will go to each preset position sequentially by the preset
dwelling time. Select the dwelling time (3-60sec) from the
above column by using the down arrow button, then click on
Seq button to start the Sequence Mode. Click on Seq button
again to stop.
Iris – To adjust the brightness level of the PTZ camera. Click
on Inc. to get brighter picture. Click on Dec. to get darker
picture.
45