Ness PowerPlex EDR400 Instruction Manual page 15

Config – To configure (setup) the behaviors of the system.
Login – To login the system as Administrator, Supervisor or Operator.
Sequence Mode / Static Page Mode – To toggle between Sequence
Mode and Static Page Mode. In Sequence Mode, each page in the
designated sequence will be shown for its preset dwelling time
sequentially. To select the Sequence, click on the Up/Down buttons
beside the displayed sequence number. In Static Page Mode, the
selected multi-window display will always be shown on the screen.
Full Screen Display (Static Page Mode)
4-window Display (Static Page Mode)
7-window Display (Static Page Mode)
9-window Display (Static Page Mode)
10-window Display (Static Page Mode)
13-window Display (Static Page Mode)
16-window Display (Static Page Mode)
Pause/Circulate – To toggle between Pause Mode and Circulate
Mode for status indication.
Next Device – To change the status indication to next device while
it's in Pause Mode.
Hard Disk Storage Indicator – To indicate the storage status and the
36%
recording percentage of the current recording hard disk. There are 3
different colors of the indicator:
GREEN – Normal, the remaining storage is more than 10% of the
total capacity.
YELLOW – Warning, the remaining storage is below 10% of the
total capacity.
RED – Alarm, the remaining storage is below 5% of the total
capacity
.
There are 4 kinds of devices in the status indication. The displaying
Administrator's Guide and Operating Instructions
11