Dish Network DishPro User Manual page 94

Chapter 4
Installation Instructions
Page 92
C E R
ONNECTING ACH
You must keep each receiver connected to an active telephone line.
Otherwise, you may not be able to order pay per view programs. Run
a telephone cable with a standard RJ-11 connector from each
receiver's back panel
You may be able to use a wireless telephone extender. However,
Note:
this may not support all the features of some receivers.
You must also set up each receiver for your telephone system
(touchtone or rotary/pulse), and set a telephone number prefix, if you
need a prefix to make an outside call.
1. Display the
Installation and Setup
2. Select the
Telephone System
System Setup menu.
3. Select the Touch Tone
list.
Usually, you need a telephone number prefix only for business
Note:
installations. For most residential installations, all you need to do is
set the telephone system type. The default setting of
needed will allow correct dialing. If this is the case, select the
option to save the above setting, and stop here. If you do need to set
a prefix, then instead of selecting the
4. Move the highlight to the
option in the Outside Line Prefix
the highlighted option.
5. If you selected the One-digit code
highlights a box where you must enter the digit.
If you selected the
Two-digit code
boxes (highlighting the top box) where you must enter the digits. To
do this, do the following:
T
ECEIVER TO A ELEPHONE
Phone Jack to an active telephone connection.
menu.
option to display the
or the Rotary/Pulse option in the
Save
or the
One-digit code
list.Press the
option, the receiver displays and
option, the receiver displays two
L
INE
Telephone
Phone Type
No Prefix
Save
option, go on to step 4.
Two-digit code
Select button to select