Dish Network DishPro User Manual page 59

5. Press the blank Power button.
6. Press the up or down arrow button to set the remote to the next code.
7. If the remote reaches the correct code, the device turns off.
8. Press the blank Power button to turn the device back
9. Try some other buttons to make sure they work.
1. Use the device's buttons or its remote control to turn it on.
2. Find the brand name of the device in the tables on page 105. If the
3. Press and hold the mode button for the device you want the remote to
4. Only for the Aux mode, use a number button to enter 0 for a second
5. Use the number buttons to enter a device code from the table.
6. Press the Pound (#) button. If the code works, the mode button
Tip: The
7. Press the blank Power button to test if the code works
procedure at the
left explains
how to find out 8. Turn the device back on and try some other buttons to
the device code
you set for each
remote control
mode.
9. If the code you entered doesn't work, do steps 3 through 8 again with
You can find out what device code you've set for each remote mode.
The up arrow button scans ahead and the down arrow button scans
back. Press the button again to go on with the scan.
When this happens, press the Pound (#) button to store the
code in the remote. If the code works, the mode button
flashes three times.
on.
Sometimes, the blank Power button works when
other buttons don't.
The mode button for the device starts to flash if you've scanned
Note:
all the codes for that device.
Try the Device Codes
If you just did Scan for Device Codes, you don't need to do
Note:
this.
brand isn't listed, please see the section titled Scan for Device Codes,
below.
control, for about three seconds. When all the other mode buttons
light up, let go of the mode button.
TV, 1 for a second VCR, or 2 for a tuner or amplifier. For any other
mode, skip to step 5.
flashes three times.
for the device. If it does, the device should turn off.
make sure they work. Sometimes, the blank Power
button works when other buttons don't. If the code
works for other buttons, stop here.
another code from the tables.
Check the Device Codes
Control Other Devices with the Remote
lPage 57