Dish Network DishPro User Manual page 55

Use the Up/Down arrow buttons to change channels on the TV.
R B
ECALL UTTON
Press this button to return to the last channel you were watching. Press it
again to switch between the last two channels that you watched.
N
UMBER
Use these buttons to enter numbers in a menu, or to go directly to a new
channel.
C VCR (V
ONTROL A IDEO
Some of the features described below may not
apply to the VCR. See your VCR owner's manual
for details about the VCR's features. If a remote
control button is not described in this section, it
does not work in VCR mode.
VCR M
ODE
To use the remote to operate a VCR, you must first set up the remote to
control the VCR, then you must press the VCR mode button to set the remote
to VCR mode. The VCR mode button's back light turns ON to show that the
remote is set to VCR mode. Make sure to keep the remote in VCR mode to
use the buttons as described in this section.
You must set the remote control to VCR mode to
set it up to control a DVD player. You must set the
remote control to VCR mode to use it to control a
DVD player.
M B
UTE UTTON
Press this button to turn off the sound. Press it again to restore the sound.
V
OLUME
Press the left-hand, minus (-) side of this button to lower the sound volume.
Press the right-hand, plus (+) side of this button to raise the sound volume.
B
UTTONS
C R
ASSETTE ECORDER
B
UTTON
B
UTTON
Control Other Devices with the Remote
) S VCR
OR ECOND
Tip: To operate
another device
such as a VCR,
you must first set
up the remote to
control the VCR,
and then press
the VCR mode
button on the
remote.
lPage 53