Dish Network DishPro User Manual page 71

•If, by chance, the number for the satellite you want to point at appears on
the Satellite line, go to step #8.
8. Select OK to exit back to the Point Dish/Signal menu.
9. Point the dish for the strongest possible signal, following the instructions
that came with it.
10. Connect any switches in your system, using the instructions that came
with the switch(es).
11. Select Check Switch from the Point Dish/Signal menu. When the
Check Switch menu opens, select Check. it the procedure completes,
you will see the Installation Summary screen again.This time you
should confirmation for all satellites your dish is pointed at. see the
satellite your dish is pointed at, and you should also see that the
switch(es) in your system has been correctly identified. Refer to the
DishPro wiring diagrams for examples of installation summary screens.
12. Select OK to exit this menu, and then Cancel to exit the Point
Dish/Signal screen.
Now, turn the page to see alternate DishPro wiring diagrams.
Installing a Multiple Dish DishPro system
lPage 69