Dish Network DishPro User Manual page 85

all the bolts in the dish assembly so that the dish cannot be moved.
10.Mark the final locations on the mast and mounting bracket with a
permanent marker. This assists you later if you have to realign the dish
because of movement due to wind or weather. Do not scratch the painted
surfaces to mark them. This will cause rusting.
11. Connect the LNBFs to the switch(es). (See the Alternate Wiring diagrams
on page 84 for more information.)
12. Connect the switch(es) to the receiver.
13. Run Check Switch from the Point Dish/Signal menu. Verify that you
have signals from all the satellites in your system and that the correct
switches have been identified.
Installing a Legacy Multiple Dish System
lPage 83