Dish Network DishPro User Manual page 90

Chapter 4
Installation Instructions
Page 88
T D , T D
WO ISHES HREE
T SW21 S
WO WITCHES
This diagram omits grounding for clarity. Make
sure to ground the system per the National
Electrical Code (NEC) and all local electrical
codes. See Grounding the System for grounding
procedures.
Note: In this installation, only two receivers will get signal from all
three LNBFs. The other two receivers will get signal from only two
LNBFs.
When you set up your system following this diagram and run Check
Switch the Installation Summary screen should look similar to
the one shown below.
-O LNBF , O
UAL UTPUT S
, F R
OUR ECEIVERS
SW44 S ,
NE WITCH