Installing A Receiver Into An Existing System - Dish Network DishPro User Manual

Appendix A
W
HAT KIND OF
These instructions are to guide you through the installation of new satellite
receiver in an existing system where your satellite dish(es) has already been
installed and pointed for the strongest possible signal. If your DISH antenna(s)
is not already installed, you will need to go to page 59, and follow the
Installation Instructions you will find there.
There are two families of satellite receivers that are covered by these
installation instructions.
• Dishpro Receivers which have the DishPro logo shown below.
• Legacy receivers which do not have the DishPro logo.
Both types of receivers can be installed in Dish antenna systems with either
DishPro LNBFs and switches (with the DishPro logo) or Legacy LNBFs and
switches (without the DishPro logo).
The first step is to identify whether your new receiver is DishPro or Legacy.
Then:
• If the new receiver has the DishPro logo and your existing system
has DishPro LNBFs, follow the instructions on the following page
titled
Installing a DishPro Receiver in an Existing System with
DishPro LNBFs. This will tell you how to install your receiver, and
then allow it to take a special software upgrade.
• If your new receiver
ing system does have DishPro LNBFs and switches, you will need a
DishPro adapter. For more information on this, contact your DISH
Network retailer or call 1-800-333-DISH (3474) for more informa-
tion. You will find the instructions for doing this installation with
the DishPro adapter.
• If you are installing either a DishPro or Legacy receiver into an
existing system with Legacy LNBFs and switches, you will need to
go to page 116 and follow the instructions titled Installing a
DishPro or Legacy Receiver in an Existing System with
Legacy LNBFs.
R Y
ECEIVER DO OU
have the DishPro logo and your exist-
does not
H ?
AVE
Page 113