Dish Network DishPro User Manual page 30

Chapter 3
Using the System
Page 28
S P
ELECTING A ROGRAM IN THE
1. Use the number pad buttons to enter the desired channel number. The
Program Guide displays a block of channels including the one that
you just entered.
2. Use the Up/Down/Left/Right buttons to move the highlight to the
desired program.
3. You may press the Information button for more
information about the highlighted program.
4. Press the Cancel button to return to the
Program Guide.
5. Press the Select button to change to the new
channel.
6. You may press the Page Up or Page Down arrow
button to scan, page by page, through the listing of channels.
7. Note: The remote must be in SAT mode to do this.
Note: The use of these buttons in VCR mode is covered in the section
titled Control Other Devices with the Remote beginning on page 51.
You may skip the display forward or backward. To do this, enter the
number of hours that you want to skip, using the number pad buttons
(the number of hours you choose will be displayed in the white area
third from the top of the Program Guide). Then, press the Left or
Right arrow button.
Note: The Program Guide can display programs scheduled
for some time beyond the present, but cannot display programs that
have ended.
C T P
LOSING HE ROGRAM
To close the Program Guide, press the remote control Cancel button.
The receiver displays the program you were watching before you opened
the Program Guide.
P G
ROGRAM UIDE
G
UIDE