Installing A Dishpro Or Legacy Receiver In An Existing System With Legacy Dual Lnbfs; In An Existing System With Legacy Twin Lnbf - Dish Network DishPro User Manual

Appendix A
Page 116
and the message "Satellite reception verified." If not, you will need to
check all your cables and connections, and then run Check Switch again.
I D
NSTALLING A ISH
E S
XISTING YSTEM WITH
Note: Use RG-6 cable for all receiver to switch or LNBF connections,
and make sure there is less than 100 feet of cable between the receiver and
the dish.
1. Connect the new receiver's TV Out to your television's RF tuner input
using coaxial cable. Check to see that the Channel 3/4 switch on the
new receiver's back panel is set to the same channel 3 or 4 as your TV.
Make sure both the receiver and TV are turned on.
2. Go to page page 76 and do steps #6 through #12, omitting steps #8
and #9as your dish is already pointed for the strongest possible sig-
nal.
I D
NSTALLING A ISH
E S
XISTING YSTEM WITH
Note: Use RG-6 cable for all receiver to switch or LNBF connections,
and make sure there is less than 100 feet of cable between the receiver and
the dish
1. Connect the new receiver's TV Out to your television's RF tuner input
using coaxial cable. Check to see that the Channel 3/4 switch on the
new receiver's back panel is set to the same channel 3 or 4 as your TV.
Make sure both the receiver and TV are turned on.
2. Go to page page 79 and do steps #6 through #12, omitting steps #7
and #8 as your dish is already pointed for the strongest possible sig-
nal.
P L R
RO OR EGACY
L D
EGACY UAL
P L R
RO OR EGACY
L T
EGACY WIN
ECEIVER IN AN
LNBF
S
ECEIVER IN AN
LNBF