Testing The System - Dish Network DishPro User Manual

Chapter 3
Using the System
Tip: Before you do
the telephone test,
make sure that an
active telephone
line is connected
to the Telephone
Jack on the
receiver back
panel.
Page 58
:
Here's what to do
1. Press and hold the mode button for the device, for about three
seconds. When all the other mode buttons light up, let go of the
mode button.
2. Press the Pound (#) button twice. The mode button
flashes the number for each digit of the device code, with
a pause between the groups of flashes. A quick flash is for
zero. For example, the mode button flashes five times, pauses,
flashes seven times, pauses, and flashes once quickly for the 570
code.
T S
ESTING THE YSTEM
S T
TARTING A EST
1. Press the Menu button.
2. Select the System Setup option.
3. Select the Diagnostics option.
T C
ELEPHONE ONNECTION
This test checks that the receiver telephone connection is correct. Select
the Connection option to begin the test. The receiver displays a message
asking you to wait until the test is done.
• If the telephone connection is correct, the receiver displays a
Phone Connection OK message.
• If the receiver highlights the Cancel option, you must choose the
Dial Out option so the receiver can make a toll-free call to the
Customer Service Center. Press the remote control Select button
to start the call. The receiver displays a message asking you to
wait until the call is done. When the call is done, select the
Cancel option to exit the test menu.
• If the telephone line is not connected properly, the receiver
displays a failure message. In this case, check the telephone
connection and then repeat the test.
Note:
If you have the receiver connected to a DSL (Digital Subscriber Line)
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the receiver and the phone jack on the wall. You should be able to
get a DSL filter from your DSL provider, or your local electronic parts store.
T
EST