Dish Network DishPro User Manual page 70

Chapter 4
Installation Instructions
Page 68
Once you have installed the DISH 500 with DishPro LNBFs (using
the preceding instructions), you can now install a DISH 300 with a
single DishPro LNBF as follows:
1. Turn on the television and the receiver if they are not already on. You
should see the Point Dish/Signal screen. If not, open the Main
Menu and press 6-1-1 on the remote.
2. Make sure there is a check mark next to the satellite your dish will be
pointing at. If there is not, use the Up and Down arrows on the remote
to move the highlight to the box next to the correct satellite, and then
press select on the remote.
3. Enter your Zip code to get the necessary azimuth and elevation. Write
these down below.
Azimuth:___________ Elevation:___________
4. Mount the dish following the mounting instructions that came with it.
5. Connect an RG-6 cable from the TV Set Out port on the DishPro
receiver's back panel directly to the single DishPro LNBF on the
DISH 300. Make sure there are no multi-dish switches between the
LNBF and the DishPro receiver (refer to the wiring diagrams that
begin on page 84 for detailed cabling instructions).
6. Select Check Switch from the Point Dish/Signal menu. When the
Check Switch screen opens, select Check.
7. When Check Switch is complete, you will see an Installation
Summary screen similar to the one shown below.
It should show a connection ("Conn" next to satellite) and
device under
Single
receiver his connected to the DishPro single LNBF. If your
screen matches this description, go to step #8. If not, do one of
the following:
•If "Xs" appear in the Satellite line, check all connections and then
select Retest to run Check Switch again.
(Dish Input). This means that your
1