Dish Network DishPro User Manual page 83

If the answer is no, you will need to repoint your dish following the
preceding steps until the mounting and positioning is complete and you
10. Once the software upgrade is complete, you will see a message that your
receiver's memory is being upgraded.
While this message is displaying, the green power light on the receiver's
front panel will blink. Do not disturb the receiver while the green light is
blinking.
This message may disappear, your screen may go blank for a few minutes,
and the green light may continue to blink. This is normal and does not
indicate a problem with the receiver.
11. When the software upgrade finishes, you need to return to the Point
Dish/Signal screen. To do this, open the Main Menu and press
6-1-1 on the remote.
12. Select Check Switch from the Point Dish/Signal menu. When the
Check Switch menu opens, select Check. The receiver will check your
satellite system. After the system checks your installation, an
Installation Summary screen will appear. Verify that the 500 Twin is
displayed, and the 119 and 110 satellites are verified. Select OK.
13. At the Point Dish/Signal menu, select the 110 West option and verify
that you have a green signal strength bar with a locked signal.
•If there is no signal strength on 110 West, check your connections and
select Check Switch again. If there is still no signal, confirm that
your skew angle is correct, and start over with
step #3.
•If the signal from the 110 West satellite is weak and you do not see a
green signal strength bar, repeat step #7 to fine-tune the dish until you
have about the same signal strength for both the 119 West and 110
West satellites.
14. Connect any other receivers in the system. Run Check Switch on any
receivers that have not yet taken the software upgrade to make sure they
have the latest software.
If you will be installing a multi-dish system, follow the instructions that
begin below. If not, you can skip to the section that begins on page 90
titled Grounding the System for instructions on how to ground your
system.
I L
NSTALLING A EGACY
Once you have installed the DISH 500 with its Legacy LNBFs, you can
install a DISH 300 with a Legacy LNBF as follows (please see the section
titled Alternate Legacy Wiring Diagrams for more information on wiring
the system).
1. Turn on the television and receiver. You should see the
menu
Dish/Signal .
6-1-1 on the remote.
do have the "locked" indication.
M D
ULTIPLE ISH
If you do not, open the Main Menu and press
Installing a Legacy Multiple Dish System
S
YSTEM
Point
lPage 81